Cfg-Restore Config_Bkp - HP Aruba JL253A Management And Configuration Manual

exit
vlan 4
name "VLAN4"
no ip address
exit
vlan 5
name "VLAN5"
no ip address
exit
Successfully applied configuration 'config' to running configuration.

cfg-restore config_bkp

Syntax
cfg-restore {tftp <ip-address> | sftp <ip-address>} config_bkp
Description
Downloads and restores a configuration from the TFTP or SFTP server, without rebooting the switch.
NOTE: The commands from the restored configuration will be executed on the running configuration.
The name of the current active configuration will not change after a configuration restore.
Command context
config
Example
switch(config)# cfg-restore tftp
HOSTNAME-STR
IP-ADDR
IPV6-ADDR
switch(config)# cfg-restore sftp
HOSTNAME-STR
IP-ADDR
IPV6-ADDR
user
USER@IP-STR
switch(config)# cfg-restore tftp 10.100.0.12 pvos/tftp_2930_config_file
Current running-configuration will be replaced with 'tftp_2930_config_file'.
Continue (y/n)? y
Configuration restore is in progress, configuration changes are temporarily disabled.
Successfully applied configuration 'tftp_2930_config_file' to running configuration.
switch(config)# sh cfg-restore status
Status
Config File Name
Source
Time Taken
Last Run
Recovery Mode
Failure Reason
Number of Add Commands
Number of Remove Commands : 7
Chapter 15 Configuration backup and restore without reboot
Specify hostname of TFTP Server.
IP Address of the TFTP Server.
IPV6 Address of the TFTP Server.
Specify hostname of the SFTP server.
IP Address of the SFTP Server.
IPV6 Address of the SFTP Server.
Specify username on the remote system information
Specify username along with remote system
information
: Success
: tftp_2930_config_file
: TFTP
: 4 Seconds
: Wed Nov 8 21:11:10 2017
: Enabled
: -
: 4
567