Viewing Poe Status On All Ports - HP Aruba JL253A Management And Configuration Manual

brief
<port-list>
<slot-id-
range>
The show power-over-ethernet displays data similar to that shown in show power-over-ethernet
command output on page 119.
show power-over-ethernet command output
switch(config)# show power-over-ethernet
Status and Counters - System Power Status
Pre-standard Detect
System Power Status
PoE Power Status
Chassis power-over-ethernet
Total Available Power
Total Failover Power
Total Redundancy Power :
Total Used Power
Total Remaining Power
Internal Power
1 300W/POE
2 300W/POE
3 Not Connected.
4 Not Connected.
External Power
EPS1
EPS2

Viewing PoE status on all ports

Syntax:
show power-over-ethernet brief
Displays the port power status:
PoE Port
Power Enable
Power Priority
Alloc by
Chapter 4 Power Over Ethernet (PoE/PoE+) Operation
Displays PoE information for each port. See Viewing PoE status on all ports on page
119.
Displays PoE information for the ports in port-list. See Viewing the PoE status on
specific ports on page 121.
Displays PoE information for the selected slots. See Showing the PoE information by
slot).Enter the all option to display the PoE information for all slots.
: On
: No redundancy
: No redundancy
: 600 W
: 300 W
0 W
: 9 W +/- 6W
: 591 W
/Connected.
/Connected.
/Not Connected.
/Not Connected.
Lists all PoE-capable ports on the switch.
Shows Yes for ports enabled to support PoE (the default) and No for ports on which PoE is
disabled.
Lists the power priority (Low, High, and Critical) configured on ports enabled for PoE. (For
more information on this topic, see Configuring PoE operation on page 109.)
Displays how PoE is allocated (usage, class, value).
Table Continued
119