Dhcpv6-Relay Option 79; Snmp-Server Enable Traps Dhcpv6-Snooping - HP Aruba JL253A Management And Configuration Manual

Validation rules
Validation
Verify max-bindings value entered is in the range
If DHCPv6-Snooping is already configured before
entering the command and current bindings are
greater than the value being set.
If the value is being configured for a trusted port
If the value is being configured for a port which is
not a part of a dhcpv6-snooped vlan
If the max-binding value is being set for a Dynamic
trunk.
If the number of static bindings is greater than the
max-binding value being set.
If a port on which max-binding is enabled is being
put into a trunk.
If a trunk has max-bindings configured on it. And the
trunk is being removed.
If DT trunk is being configured on a max-binding
enabled port.
IMPORTANT: DT trunks can use jumbo VLAN as usual, but user needs to ensure that jumbo is
configured on both the DT pairs, otherwise packet drops/fragmentations can be seen.
dhcpv6–relay option 79
Syntax
[no] dhcpv6-relay option 79
Description
Enabling option 79 will force the DHCPv6 Relay agent to forward the client Link-layer address. Defaults to
disabled.

snmp-server enable traps dhcpv6-snooping

Syntax
[no] snmp-server enable traps dhcpv6-snooping [out-of-resources|errant-reply]
Chapter 9 DHCPv6 server
Error/Warning/Prompt
Invalid input: <value>
Existing bindings %d are more than the max-
bindings being configured, and the maximum
limit will be applied once the number of existing
bindings fall below this limit
Cannot configure maximum binding for DHCPv6
snooping feature on a trusted port
Port %s is not a part of a DHCPv6-snooping
VLAN.
Cannot configure DHCPv6 Snooping on a port
when Dynamic Trunking is enabled on that port.
Cannot configure the maximum binding value
because the number of static bindings on the
port exceeds the maximum binding value.
Cannot add a port to a trunk group when
DHCPv6 Snooping Maxbinding is configured on
that port.
Cannot remove the port %s from the trunk group
because DHCPv6 Snooping max-binding is
configured on the trunk and removing the port
will delete the trunk.
Cannot configure Distributed Trunking on a port
when DHCPv6 Snooping max-binding is
configured on that port.
277