Fault-Finder Multicast-Storm - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

fault-finder multicast-storm

Syntax
fault-finder multicast-storm <PORT-LIST> action {warn | warn-and-disable <Seconds>} {percent <Percent> | pps <Rate>}
no fault-finder multicast-storm <PORT-LIST> action {warn | warn-and-disable <Seconds>} {percent <Percent> | pps <Rate>}
Description
Per-port command to configure multicast-storm. The no form of the command disables multicast-storm
configuration on the port.
Parameters
PORT-LIST
Enable multicast storm control on a list of ports.
Seconds
Configure the number of seconds for which the port remains disabled.
Percent
Rising threshold level as a percentage of bandwidth of the port. The percentage is calculated on 64 byte
packet size.
Rate
Rising threshold level in number of multicast packets per second
Command context
config
Examples
switch(config)# fault-finder multicast-storm
action
[ethernet] PORT-LIST
sensitivity
switch(config)# fault-finder multicast-storm ethernet
PORT-LIST
switch(config)# fault-finder multicast-storm ethernet 1/1
action
switch(config)# fault-finder multicast-storm ethernet 1/1 action
warn
warn-and-disable
switch(config)# fault-finder multicast-storm ethernet 1/1 action warn-and-disable
SECONDS
switch(config)# fault-finder multicast-storm ethernet 1/1 action warn-and-disable 10
percent
pps
84
Configure the action taken when a fault is detected.
The ports on which to enable Multicast Storm Control.
Configure the fault sensitivity level.
Enter a port number, a list of ports or 'all' for all
ports.
Configure the action taken when a multicast storm is
detected.
Log an event only.
Log an event and disable the port.
Configure the number of seconds for which the port
remains disabled. A value of 0 means that the port will
remain disabled until manually re-enabled.
Configure the number of inbound multicast packets per
second that is considered a multicast storm. This
threshold is computed assuming a size of 64 bytes per
incoming multicast packet.
Configure the number of inbound multicast packets per
second that is considered a multicast storm.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Advertisement

Table of Contents
loading

Table of Contents