HP Aruba JL253A Management And Configuration Manual page 189

Displays information about the management stations configured on VLAN 1 to access the switch.
Display of the management stations configured on VLAN 1
switch# configure terminal
switch(config)# vlan 1
switch(vlan-1)# show snmpv3 user
Status and Counters - SNMPv3 Global Configuration Information
User Name
-----------
initial
NetworkAdmin
Assigning users to groups (CLI)
Next you must set the group access level for the user by assigning the user to a group. The access level for the
user is done with the snmpv3 group command as shown in the following image. For more details on the MIBs
access for a given group, see Group access levels on page 190.
Figure 24: Example: of assigning users to groups
Syntax:
[no] snmpv3 group
Assigns or removes a user to a security group for access rights to the switch. To delete an entry, all the following
three parameters must be included in the command:
group <group_name>
user <user_name>
sec-model {<ver1 | ver2c |
ver3>
Chapter 7 Configuring for Network Management Applications
Auth. Protocol Privacy Protocol
-------------- -----------------
MD5 CFB AES-128
MD5 CBC-DES
Identifies the group that has the privileges that will be assigned to the user.
For more details, see Group access levels on page 190.
Identifies the user to be added to the access group that must match the
user name added with the snmpv3 user command.
Defines which security model to use for the added user. An SNMPv3
access group use only the ver3 security model.
189