Table of Contents
Advertisement
module 1 type jl071x
flexible-module A type JL081A
snmp-server community "public" unrestricted
oobm
ip address dhcp-bootp
exit
vlan 1
name "DEFAULT_VLAN"
untagged 1-24,A1-A4
ip address dhcp-bootp
ipv6 enable
ipv6 address dhcp full
exit
amp-server ip 2001:1db8:3cd4:1115:1111:2222:1a2f:1a2b group "grp21" folder "fld21"
secret "scrt21"
NOTE: ipv6 enable and ipv6 address dhcp full are enabled by default on VLAN 1 from
16.06 switch version.
debug ztp
Syntax
debug ztp
no debug ztp
Description
Enables or disables ZTP debug logging.
Parameters and options
ztp
Zero Touch Provisioning.
no
The no debug ztp command disables ZTP debug logging.
Stacking support
The ZTP process for stacked switches with AirWave is similar to the one for the standalone switch, with the
exception that only the commander in the stack checks in with AirWave.
Disabling ZTP
ZTP is disabled if you make any of the following changes to the switch configuration:
•
Enter the switch configuration mode using the configure terminal command.
•
Enter into Menu and exit without doing any configuration
•
Use CLI, SNMP, REST APIs, menu interface, or the web GUI to configure any settings. The change is shown
in the running-configuration of the switch.
•
When device is upgraded from any 15.xx version to 16.01, see Image Upgrade.
•
Once DHCP server or Activate offers Airwave/Central details, ZTP is disabled. If the details are offered again,
it is ignored.
312
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
Advertisement
Table of Contents
Troubleshooting
