Displaying Information About The Mac-Count-Notify Option - HP Aruba JL253A Management And Configuration Manual

Configuring mac-count notify traps on ports 5–7
switch (config)# mac-count-notify traps 5-7 50

Displaying information about the mac-count-notify option

Use the show mac-count-notify traps [<port-list>] command to display information about the configured value for
sending a trap, the current count, and if a trap has been sent.
Information displayed for the show mac-count-notify traps command
switch(config)# show mac-count-notify traps
Mac-count-notify Enabled: Yes
Port Count for
sending Trap
------ ---------------
1
2
3
4
5 50
6 50
7 50
8
9
...
The interface context can be used to configure the value for sending a trap.
Configuring mac-count-notify traps from the interface context
switch(config)# interface 5
Switch (eth-5)# mac-count-notify traps 35
The show snmp-server traps command displays whether the MAC Address Count feature is enabled or
disabled.
Information about SNMP traps, including MAC address count being Enabled/Disabled
switch(config)# show snmp-server traps
Trap Receivers
Link-Change Traps Enabled on Ports [All] : All
Traps Category
____________________________
SNMP Authentication
Password change
Login failures
Port-Security
Authorization Server Contact : Enabled
DHCP-Snooping
Dynamic ARP Protection
Dynamic IP Lockdown
212
Count Trap Sent
------- ------------
0 No
2 No
0 No
Current Status
__________________
: Extended
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
: Enabled
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08