HP Aruba JL253A Management And Configuration Manual page 628

NOTE: Requires (config)#show run context:
; J9850A Configuration Editor; Created on release #KB.16.05.0000x
; Ver #12:08.1f.fb.7f.bf.bb.ff.7c.59.fc.7b.ff.ff.fc.ff.ff.3f.ef:f4
hostname "Anay5400R"
module A type j9989a
module B type j9986a
module C type j9989a
module D type j9986a
module E type j9986a
module F type j9986a
class ipv4 "testclass"
10 match ip 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255
20 match tcp 0.0.0.0 255.255.255.255 0.0.0.0 255.255.255.255
exit
policy user "testpolicy"
10 class ipv4 "testclass" action permit
exit
radius-server host 90.90.90.1
ip routing
ip source-interface tunneled-node-server loopback 1
tunneled-node-server
controller-ip 21.1.1.2
mode role-based
exit
Reserved VLAN
Syntax
tunneled-node-server mode role-based reserved-vlan <VLAN-ID>
no tunneled-node-server mode role-based reserved-vlan <VLAN-ID>
Description
Enable tunneled node server with a reserved VLAN on which all client traffic is sent to the controller.
Example
To configure a tunneled node server in role-based reserved VLAN mode:
switch(tunneled-node-server)# mode
port-based
role-based
switch(tunneled-node-server)# mode role-based
reserved-vlan
vlan.
switch(tunneled-node-server)# mode role-based reserved-vlan
VLAN-ID
switch(tunneled-node-server)# mode role-based reserved-vlan <VLAN-ID>
show tunneled-node-server output:
switch(config)# show tunneled-node-server
Tunneled Node Server Information
State
Primary Controller
Backup Controller
Keepalive Interval (seconds)
628
Configure tunneled node server mode as port based.
Configure tunneled node server mode as role based.
Configure VLAN Mode as No-VLAN, switch without tunneled-node client's
Configure VLAN to be created and reserved for tunneled-node clients.
: Enabled
: 10.0.0.1
:
: 8
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08