Table of Contents
Advertisement
<1-5>] [source {<ip-address | source-vlan <vid> | loopback <0-7>}] [dstport
<1-34000>] [srcport <1-34000>] [ip-option {<record-route | loose-source-route |
strict-source-route | include-timestamp | include-timestamp-and-address | include
timestamp-from>}] [< timeout 1-120 >]
Lists the IP address or hostname of each hop in the route, plus the time in microseconds for the traceroute
packet reply to the switch for each hop.
{< ip-address |
hostname >}
[minttl < 1-255 >]
[maxttl < 1-255 >]
[probes < 1-5 >]
[source {< ip-
addr | vid |
loopback <0-7> >}]
[dstport <
1-34000 >]
Chapter 13 Troubleshooting
The IP address or hostname of the device to which to send the traceroute.
For the current instance of traceroute, changes the minimum number of hops
allowed for each probe packet sent along the route.
•
If minttl is greater than the actual number of hops, the output includes only the
hops at and above the minttl threshold. (The hops below the threshold are not
listed.)
•
If minttl matches the actual number of hops, only that hop is shown in the
output.
•
If minttl is less than the actual number of hops, all hops are listed.
For any instance of traceroute, if you want a minttl value other than the default,
you must specify that value.(Default: 1)
For the current instance of traceroute, changes the maximum number of hops
allowed for each probe packet sent along the route.If the destination address is
further from the switch than maxttl allows, traceroute lists the IP addresses for
all hops it detects up to the maxttl limit.For any instance of traceroute, if you
want a maxttl value other than the default, you must specify that value.(Default: 30)
For the current instance of traceroute, changes the number of queries the switch
sends for each hop in the route.For any instance of traceroute, if you want a
probes value other than the default, you must specify that value.(Default: 3)
The source IPv4 address, VLAN ID, or Loopback address.
Destination port.
Table Continued
531
Advertisement
Table of Contents
Troubleshooting
