Validation Rules - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

Validation rules

Validation
Enabling SLA without configuring SLA type.
IP address given for source or destination is
multicast or broadcast.
Configure the SLA type with a source IP which
is configured in the same switch.
Configure threshold with invalid value.
Configure threshold value for 'PacketLoss' or
'TestCompletion'
Configure threshold type for TestCompletion.
Configure schedule with proper end time with a
frequency which is out of end time.
Configuring 'srcTodstTime' or 'dstTosrcTime'
threshold configuration for 'icmp-echo' or 'tcp-
connect'.
Enabling the IP SLA which is already in enabled
state.
Disabling the IP SLA which is already in
disabled state.
Show IP SLA history of un-configured SLA.
Enable more number (currently decided 50 as
limit) of IP SLA.
Removing IP SLA type/tos/history size/
schedule/ threshold configuration with un-
configured value.
Configuring scheduler with a frequency value
which is not satisfying the condition frequency >
number of packets per probe * packet interval.
Scheduler already configured and try to
configure SLA type with a value of 'number of
packets per probe' and 'packet interval' which is
not satisfying the condition frequency > number
of packets per probe * packet interval.
Chapter 17 IP Service Level Agreement
Error/Warning/Prompt
Cannot enable IP SLA, no valid source/destination configured.
Invalid IP address.
Destination IP cannot be configured as the same as one of the
local interface IP addresses.
Invalid threshold count value. For threshold type 'Immediate',
count must be 1 and for 'Consecutive', count must be greater
than or equals to 2.
Configuration is not applicable when threshold is configured
for 'PacketLoss' or 'TestCompletion'.
Configuration is not applicable when threshold is configured
for 'TestCompletion'.
Invalid endtime. Endtime is not enough to run the tests for
configured frequency and repetitions.
Invalid threshold configuration for configured SLA type.
IP SLA is already enabled.
IP SLA is already disabled.
IP SLA is not configured for this ID.
Maximum number of enabled IP SLAs at a time is limited to
50.
IP SLA configuration does not exist.
Frequency value is insufficient to configure the scheduler.
Number of packets/packet interval is insufficient to configure
IP SLA type.
Table Continued
601

Advertisement

Table of Contents
loading

Table of Contents