Event Log Messages; Locating A Switch (Locator Led) - HP Aruba JL253A Management And Configuration Manual

Event Log messages

Please see the Event Log Message Reference Guide for information about Event Log messages.

Locating a switch (Locator LED)

To locate where a particular switch is physically installed, use the chassislocate command to activate the blue
Locator LED on the switch's front panel.
Syntax:
chassislocate [blink | on | off]
Locates a switch by using the blue Locate LED on the front panel.
blink <1-1440>
on <1-1440>
off
Locating a switch with the chassislocate command
switch(config)# chassislocate
blink <1-1440>
off
on <1-1440>
switch(config)# chassislocate
For redundant management systems, if the active management module failsover, the Locator LED does not
remain lit.
550
Blinks the chassis Locate LED for a specified number of minutes (Default: 30
minutes).
Turns the chassis Locate LED on for a specified number of minutes (Default: 30
minutes).
Turns the chassis Locate LED off.
Blink the chassis locate led (default 30 minutes).
Turn the chassis locate led off.
Turn the chassis locate led on (default 30 minutes).
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08