Statistic Interactions Of Interface Counters - HP Aruba JL253A Management And Configuration Manual

Example
Show bandwidth utilization for trunks.
Switch(config)# show interfaces trunk-utilization
Status and Counters - Port Utilization
Port | --------------------------- | ---------------------------
| Kbits/sec
-------- ---------- ----- + ---------- ---------- ---------
Trk1 | 0
Trk2 | 0
Trk10 | 0

Statistic interactions of interface counters

Table 27: Statistic interactions
Interface counters are cleared using the command clear statistics. When certain actions are taken to ports
and trunks, the outcome of the clear command differs.
Action taken Trigger
Adding Port
into trunk
Removing
Port from
trunk
Trunk port
coming Up
Trunk port
coming Up
Trunk port
going Down
Trunk port
going Down
396
Rx
Pkts/sec
0
0
0
Interaction with interface counter
CLI/SNMP • Interface counters for this port will be cleared across all sessions.
• Average rate counters are not cleared.
CLI/SNMP • Interface counters for this port will be cleared across all sessions.
• Average rate counters are not cleared.
CLI enable • No change in counters.
• Interface counters for this port are not cleared.
• Average rate counters are not cleared. Counters will start from 0 when the
trunk port comes up.
Cable connect • No change in counters.
• Interface counters for this port are not cleared.
• Average rate counters are not cleared. Counters will start from 0 when the
trunk port comes up.
CLI disable • Interface counters for this port are not cleared.
• Average rate counters are cleared.
Cable • Interface counters for this port are not cleared.
disconnect
• Average rate counters are cleared.
Util | Kbits/sec
0 | 0
0 | 0
0 | 0
Aruba 2930F / 2930M Management and Configuration Guide
Tx
Pkts/sec Util
-----
0 0
0 0
0 0
for ArubaOS-Switch 16.08
Table Continued