HP Aruba JL253A Management And Configuration Manual page 694

--- ------------- -------------------------------------- --- ---------------
*1 b05ada-961100 Aruba JL253A 2930F-24G-4SFP+ Switch
2. Log in to the second device. This will be configured as VSF member
commands:
Switch# configure
Switch(config)# vsf member 2 priority 150
Switch(config)# vsf member 2 link 1 49-52
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 2 link 2 21-24
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf enable domain 5472
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
The above sequence of commands will configure switch 2 as the Standby, with a priority of 150. Connect links
of switch 1 and switch 2 after executing the vsf enable domain command. A 2-member stack will be
formed.
Switch# show vsf
VSF Domain ID
MAC Address
VSF Topology
VSF Status
Uptime
VSF MAD
VSF Port Speed
Software Version : WC.16.03.0000x
Mbr
ID MAC Address
--- ------------- -------------------------------------- --- ---------------
*1 b05ada-961100 Aruba JL253A 2930F-24G-4SFP+ Switch
2 b05ada-9721c0 Aruba JL260A 2930F-48G-4SFP Switch
3. Log in to the third and fourth devices. These will be configured as members
Enter the following commands on device 3:
Switch# configure
Switch(config)# vsf member 3 priority 100
Switch(config)# vsf member 3 link 1 21-24
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 3 link 2 49-52
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf enable domain 5472
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
The above sequence of commands will configure switch 3 as a Member, with a priority 100. Connect the links
of switch 2 and switch 3 after executing the vsf enable domain command. A 3-member stack will be
formed.
Switch# show vsf
VSF Domain ID
MAC Address
VSF Topology
694
: 5472
: b05ada-961103
: Chain
: Active
: 0d 3h 22m
: None
: 1G
Model
: 5472
: b05ada-961103
: Chain
Aruba 2930F / 2930M Management and Configuration Guide
200 Commander
2
. At the prompt, enter the following
Pri Status
200 Commander
150 Standby
3 4
and respectively.
for ArubaOS-Switch 16.08