Lma/Wma/802.1X/Port-Security; Troubleshooting; Dynamic Configuration Not Displayed When Using "Show Running-Config; The Show Run Command Displays Non-Numerical Value For Untagged-Vlan - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08
Table of Contents

Advertisement

blocked by rogue-ap-isolation.
Similarly, any MAC that was added with the lockout-mac or static-mac command and that is being detected
as rogue will be logged, but not blocked in hardware as it already is set to block. If the MAC is removed from
lockout-mac or static-mac but is still in the rogue device list, it will be blocked back in hardware if the action
type is block.

LMA/WMA/802.1X/Port-Security

Any configuration using LMA, WMA, 802.1X, or Port-Security will not be blocked if the Rogue AP isolation feature
is enabled. All these features act only when a packet with the said MAC is received on a port.
If rogue-ap-isolation blocks a MAC before it is configured to be authorized, packets from such MACs will be
dropped until one of the following happens:
Rogue action is changed to LOG.
Rogue-AP isolation feature is disabled.
The MAC is not detected as rogue anymore.
LLDP is disabled on the port (or globally).
Once a MAC has been authorized by one of these features, it will not be blocked by Rogue AP isolation. A RMON
will be logged to indicate the failure to block.
The Rogue AP module will retry to block any such MACs periodically. In the event of the MAC no longer being
authorized, Rogue AP isolation will block the MAC again. No RMON is logged to indicate this event.

Troubleshooting

Dynamic configuration not displayed when using "show running-config"

Symptom
The show running-config command does not display the dynamic configuration applied through the device
profile.
Cause
The show running-config command shows only the permanent user configuration and parameters
configured through device profile.
Action
Use the specific show device-profile command to display the parameters dynamically configured through
the device profile.

The show run command displays non-numerical value for untagged-vlan

Symptom
The show run command displays one of the following values for untagged-vlan:
no untagged-vlan
untagged-vlan : None
730
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08

Advertisement

Table of Contents
loading

Table of Contents