Aruba-Central - HP Aruba JL253A Management And Configuration Manual

Fields added in 16.07.
Time sync status
Activate DNS Lookup.
Proxy Server DNS Lookup
Activate Connection Status.
Error Reason

aruba-central

Syntax
aruba-central {enable | disable | support-mode {enable | disable}}
Description
Configure Aruba Central server support. When enabled, and when a server web address has been obtained using
Aruba Activate, the system will connect to an Aruba Central server. The system will obtain configuration updates
and most local configuration commands will be disabled. This mode is enabled by default.
Enter support mode to enable all configuration commands. Normally, when the system is connected to an Aruba
Central server, the configuration is updated from that server and most local configuration commands are disabled.
Support mode enables those commands for use in troubleshooting problems. Support mode is disabled by
default. When the system is not connected to Aruba Central server, the full command set is enabled for local
configuration.
Restrictions
• Switch communication to Aruba Central is not supported via OOBM.
• Aruba-central is not supported in FIPS switches and it will be disabled by default.
• Aruba-central is not supported in Stack switches and it will be disabled by default.
330
Status
• Time sync from NTP
• Time sync from HTTP
• Time sync from other source
• Not updated
• NA
• Success
• Failure
• NA
• Success
• Failure
• NA
• Success
• Failure
• NA
Aruba 2930F / 2930M Management and Configuration Guide
Validation
• Default - Not updated, time is not
updated from NTP and HTTP.
• NA - In this case switch get the
time through SNTP/ CLI/time
server configuration before NTP/
HTTP.
• Default - NA
• Other outputs are based on
device.arubanetworks.com
DNS lookup.
• NA - If proxy is not configured.
• Other outputs are based on
proxy lookup.
Default - NA
Default - NA
for ArubaOS-Switch 16.08