HP Aruba JL253A Management And Configuration Manual page 203

• Invalid password entered in a login attempt through a direct serial, Telnet, or SSH connection
• Manager password changes
• Port-security (web, MAC, or802.1X) authentication failure
• SNMP authentication failure
• Running configuration changes
Enabling or disabling notification/traps for network security failures and other security
events (CLI)
Syntax:
[no] snmp-server enable traps [arp-protect | auth-server-fail | dhcp-server
| dhcp-snooping | dhcpv6-snooping | dyn-ip-lockdown | dyn-ipv6-lockdown | link-change
| login-failure-mgr | mac-count-notify | mac-notify | macsec | nd-snooping | password-change-mgr
| port-security | running-config-change | snmp-authentication | startup-config-change | vsf ]
Enables or disables sending one of the security notification types listed below to configured trap receivers.
(Unless otherwise stated, all of the following notifications are enabled in the default configuration.)
The notification sends a trap:
arp-protect
auth-server-fail
dhcp-server
dhcp-snooping
dhcpv6-snooping
dyn-ip-lockdown
dyn-ipv6-lockdown
link-change
login-failure-mgr
mac-count-notify
mac-notify
macsec
nd-snooping
password-change-mgr
port-security
Chapter 7 Configuring for Network Management Applications
Traps for Dynamic ARP Protection.
Traps reporting authentication server unreachable.
Traps for DHCP-Server.
Traps for DHCP-Snooping.
Set the traps for DHCPv6 snooping.
Traps for Dynamic Ip Lockdown.
Enable traps for Dynamic IPv6 Lockdown.
Traps for link-up and link-down.
Traps for management interface login failure.
Traps for MAC addresses learned on the specified
ports exceeds the threshold.
Traps for (learned/removed) MAC address table
changes.
Configure the traps for MACsec notifications.
Set the trap for nd snooping
Traps for management interface password change.
Traps for port access authentication failure.
Table Continued
203