HP Aruba JL253A Management And Configuration Manual page 516

messages sent to the syslog server, specify a set of messages by entering the logging severity and
logging system-module commands.
Figure 87: Syslog configuration to receive event log messages from specified system module and severity levels
As shown at the top of Figure 87: Syslog configuration to receive event log messages from specified
system module and severity levels on page 516, if you enter the show debug command when no syslog
server IP address is configured, the configuration settings for syslog server facility, Event Log severity level, and
system module are not displayed. However, after you configure a syslog server address and enable syslog
logging, all debug and logging settings are displayed with the show debug command.
If you do not want Event Log messages sent to syslog servers, you can block the messages from being sent by
entering the no debug event command. (There is no effect on the normal logging of messages in the switch's
Event Log.)
Example:
The next Example: shows how to configure:
• Debug logging of ACL and IP-OSPF packet messages on a syslog server at 18.38.64.164 (with user as the
default logging facility).
• Display of these messages in the CLI session of your terminal device's management access to the switch.
• Blocking Event Log messages from being sent from the switch to the syslog server and a CLI session.
516 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08