Firmware Management; Enable Debug Messages; Set/Change Password; Restore Factory Defaults - HP G3 KVM User Manual

•
Enable Debug Messages (on page 68)
•
Set/Change Password (on page 68)
•
Restore Factory Defaults (on page 68)
•
Reset Switch (on page 68)
•
Set Web Interface Ports (on page 68)
•
Exit (on page 68)

Firmware Management

The Firmware Management menu contains the Flash Download selection.

Enable Debug Messages

The Enable Debug Messages option enables console status messages. Because enabling status
messages can reduce performance, enable the status messages only when instructed to do so by Hewlett
Packard Enterprise Technical Support. Press any key to exit the mode.

Set/Change Password

The Set/Change Password menu option enables and disables DIAG port security, which locks the DIAG
port with a user-defined password.

Restore Factory Defaults

The Restore Factory Defaults menu option restores all switch options to the default settings.

Reset Switch

The Reset Switch menu option executes a soft reset of the switch.

Set Web Interface Ports

The switch uses port 80 for HTTP and 443 for HTTPS. The Set Web Interface Ports menu option enables
modification or specification of alternate ports.
Reboot the switch to use new port numbers.

Exit

The Exit menu option returns to the ready prompt. If the Console menu interface password is enabled, exit
the Console Main menu so the next user is prompted for a password.
Terminal operation 68