HP Aruba JL253A Management And Configuration Manual page 571

• whether a recovery-mode was enabled
• the number of add and delete commands
• reboot commands present (if any), and
• the split time taken for each phase
Examples
switch(config)# show cfg-restore
latest-diff
status
switch(config)# show cfg-restore status
Status
Config File name : def
Source
Time taken
Last Run
Recovery Mode
Failure Reason
Number of Add Commands
Number of Remove Commands : 3
Time Taken for Each Phase :
Calculating diff
Adding commands
Removing commands
If the configuration restoration fails, the line number and the failed commands are displayed:
switch(config)# show cfg-restore status
Status
Config File name : def
Source
Time taken
Last Run
Recovery Mode
Failure Reason
Number of Add Commands
Number of Remove Commands : 3
Time Taken for Each Phase :
Calculating diff
Adding commands
Removing commands
Failed to remove commands:
Line: 12 vlan 10
Line: 15 no ipv6 nd snooping mac-check
Failed to add commands:
Line: 10 icmp 10.100.0.12 source-inter vlan 1
Line: 20 udp-echo 10.100.0.12 source vlan 1
Chapter 15 Configuration backup and restore without reboot
Shows the difference between running and back-up
configuration.
Show configuration restoration status.
: [Failed| In progress | Success | Not Started]
: [-|Tftp|sftp|Flash|REST]
: [-|20 Seconds.]
: [-|Tue March 07 22:12:16 2017.]
: Enabled
: -
: 0
: 1 Seconds
: 0 Seconds
: 0 Seconds
: Failed
: Flash
: 20 Seconds
: Sun Oct 22 20:22:54 2017
: Enabled
: Add commands have been failed
: 0
: 1 Seconds
: 0 Seconds
: 0 Seconds
571