Vsf Vlan-Mad; Vsf Lldp-Mad Ipv4 - HP Aruba JL253A Management And Configuration Manual

Parameters
<SPEED>
The allowed values for port speeds are 1g and 10g.
Usage
[no] vsf port speed <SPEED>
The no form of the command cannot be executed if there are ports configured on the link. All the ports in the link
have to be unconfigured before setting the speed to default.
Example input
Switch(config)# vsf port-speed
1g
10g

vsf vlan-mad

Syntax
vsf vlan-mad <VLAN-ID>
Description
Configure the VSF Multi-Active Detection (MAD) VLAN. The MAD VLAN is used for stack fragment discovery
when there is a stack split. Only one MAD VLAN can be configured.
Parameters
<VLAN-ID>
VLAN identifier or the VLAN name if configured. Vlan ID value can be in the range of 1 to 4096.
Usage
[no] vsf vlan-mad <VLAN-ID>

vsf lldp-mad ipv4

Syntax
[no] vsf lldp-mad ipv4 <IPV4_ADDR> v2c <COMMUNITY-STR>
Description
Enable LLDP-MAD on the VSF device.
NOTE: The command vsf lldp mad requires a peer switch to be configured as the "assist"
device. LLDP-MAD is applicable only for a two-member VSF stack.
Parameters
<IPV4_ADDR>
The IPv4 address of the MAD (Multi-Active Detection) device.
<COMMUNITY-STR>
The SNMP community string for the MAD (Multi-Active Detection) device.
Usage
Switch(config)# vsf lldp-mad ipv4
Switch(config)# vsf lldp-mad ipv4 <IPv4_ADDR>
Switch(config)# vsf lldp-mad ipv4 <MAD-IP-ADDRESS> v2c
Chapter 20 Virtual Switching Framework (VSF)
Specify the VSF ports to auto-negotiate at 1 Gbps.
Specify the VSF ports to auto-negotiate at 10 Gbps.
661