Table of Contents
Advertisement
5. Log in to the fifth and sixth devices (configured as members
a. Physically connect member 5 with member 4. Enter the following commands on device 5:
Switch# configure
Switch(config)# vsf member 5 priority 100
Switch(config)# vsf member 5 link 1 28
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 5 link 2 27
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
b. Physically connect member 6 with member 5. Enter the following commands on device 6:
Switch# configure
Switch(config)# vsf member 6 priority 100
Switch(config)# vsf member 6 link 1 29
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 6 link 2 28
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
6. Log in to the seventh and eighth devices (configured as members
a. Physically connect member 7 with member 6. Enter the following commands on device 7:
Switch# configure
Switch(config)# vsf member 7 priority 100
Switch(config)# vsf member 7 link 1 30
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 7 link 2 29
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
b. Physically connect member 8 with one link to member 1 and another to member 7. Enter the following
commands on device 8:
Switch# configure
Switch(config)# vsf member 8 priority 100
Switch(config)# vsf member 8 link 1 23
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 8 link 2 30
All configuration on this port has been removed and port is placed in VSF mode.
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
The remaining six members have priority set to 100. All the eight switches will be configured to use the
same domain ID: 5472, which will make a single stack.
7. Connect the switches together as shown. Enable VSF on each of the eight switches by executing the vsf
enable domain 5472 command. Multiple reboots of the switches may occur since the switch roles change
Chapter 20 Virtual Switching Framework (VSF)
5
6
and
respectively).
7
8
and
respectively).
691
Advertisement
Table of Contents
Troubleshooting
