Viewing A Remote Mirroring Session - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

Monitoring Sources

Viewing a remote mirroring session

After you configure session 2 for remote mirroring (Figure 55: Configuring a remote mirroring session and

monitored source on page 420), you can enter the show monitor 2 command to verify the configuration

(Figure 56: Displaying the Configuration of a Remote Mirroring Session on page 420.)

Figure 55: Configuring a remote mirroring session and monitored source

Figure 56: Displaying the Configuration of a Remote Mirroring Session

For the specified local or remote session, displays the source (port, trunk, or VLAN)

interface and the MAC address (if configured) used to select mirrored traffic.

For the selected interface, indicates whether mirrored traffic is entering the switch (in),

leaving the switch (out), or both.

Aruba 2930F / 2930M Management and Configuration Guide

for ArubaOS-Switch 16.08