Halting An Ongoing Traceroute Search; A Low Maxttl Causes Traceroute To Halt Before Reaching The Destination Address - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

NOTE: For information about traceroute6, see the IPv6 configuration guide for your switch.

Halting an ongoing traceroute search

Press the [Ctrl] [C] keys.

Executing traceroute with its default values for a destination IP address that is four hops away produces a

result similar to this:

Figure 91: A completed traceroute enquiry

Source port.

Specify an IP option, such as loose or strict source routing, or an include-timestamp

option:[include-timestamp]: Adds the timestamp option to the IP header. The

timestamp displays the amount of travel time to and from a host.Default:

9[include-timestamp-and-address]: Records the intermediate router's

timestamp and IP address.Default: 4[loose-source-route <IP-addr>] :

Prompts for the IP address of each source IP on the path.It allows you to specify the

IP addresses that you want the ping packet to go through; the packet may go through

other IP addresses as well.[record-route <1-9>] : Displays the IP addresses of

the interfaces that the ping packet goes through on its way to the destination and on

the way back.When specified without loose or strict recording, the source route is not

recorded. The source route is automatically recorded when loose or strict source

routing is enabled.Default: 9[strict-source-route <IP-addr>] : Restricts the

ping packet to only those IP addresses that have been specified and no other

addresses.[timeout <1-120>]: For the current instance of traceroute,

changes the timeout period the switch waits for each probe of a hop in the route.For

any instance of traceroute, if you want a timeout value other than the default, you

must specify that value.(Default: 5 seconds)

Aruba 2930F / 2930M Management and Configuration Guide

for ArubaOS-Switch 16.08