Table of Contents
Advertisement
NOTE: This method is applicable for a VSF stack having more than four members too.
Figure 110: Manual configuration with multiple ports bundled in a VSF link
Procedure
1. Log in to the first device. This will be configured as VSF member
commands:
Switch# configure
Switch(config)# vsf member 1 priority 200
Switch(config)# vsf member 1 link 1 49-52
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf member 1 link 2 21-24
All configuration on this port has been removed and port is placed in VSF mode.
Switch(config)# vsf enable domain 5472
To enable VSF, the REST interface will be disabled.
This will save the current configuration and reboot the switch.
Continue (y/n)? y
The above sequence of commands will configure the switch as member 1, which will boot as the Commander
with priority 200.
Switch# show vsf
VSF Domain ID
MAC Address
VSF Topology
VSF Status
Uptime
VSF MAD
VSF Port Speed
Software Version : WC.16.03.0000x
Mbr
ID
MAC Address
Chapter 20 Virtual Switching Framework (VSF)
21
22
1
23
24
49 50 51
52
49 50 51
52
21
22
2
23
24
: 5472
: b05ada-961103
: No Stack Formed
: Active
: 0d 3h 22m
: None
: 1G
Model
21
22
4
23
24
49 50 51
52
49 50 51
52
21
22
3
23
24
1
. At the prompt, enter the following
Pri Status
693
Advertisement
Table of Contents
Troubleshooting
