Table of Contents
Advertisement
poe-max-power
The maximum PoE power for the device port. The value is set based on PD Class detection and/or LLDP
negotiation. poe-max-power will have class appropriate value depending on the class of your AP. (Example:
class4 = 25.5W, class 3=13W, class2=6.49W, class1=3.84W, class0=13W)
Options
no
Removes the user-defined profiles.
Restrictions
•
You can modify the configuration parameters of the default profile, default-ap-profile, but you cannot
delete it or change its name.
•
Egress rate limiting is not supported for devices running on Aruba 2930F Switch Series.
•
The profile configuration is only applicable to access points.
device-profile type
From within the configure context:
Syntax
device-profile type <DEVICE> [associate <PROFILE-NAME> | enable | disable ]
Description
This command specifies an approved device type in order to configure and attach a profile to it. The profile's
configuration is applied to any port where a device of this type is connected.
Approved device types
aruba-ap
Aruba access point device.
arubaos-switch
ArubaOS switch
Options
From within the device-aruba-ap context
associate <PROFILE-NAME>
Associated the specified device type by profile name.
enable
Enables the automatic profile association.
disable
Disables the automatic profile association.
Usage
[no] device-profile type <DEVICE> [associate <PROFILE-NAME> |enable | disable]
NOTE: The device types supported are aruba-ap and arubaos-switch.
Chapter 21 Simplifying Wireless and IoT Deployments
715
Advertisement
Table of Contents
Troubleshooting
