Vsf Member Reboot; Vsf Member Remove; Vsf Member Remove Reboot - HP Aruba JL253A Management And Configuration Manual

vsf member reboot

Syntax
boot vsf member <MEMBER-ID>
Description
Reboot the VSF member and have it rejoin the virtual chassis with the current configuration. If the boot option is
specified, the switch will come back up with the existing member-ID and rejoin the virtual chassis with the current
configuration.
Parameters
<MEMBER-ID>
The VSF member-ID for the member command or parameter. Member ID value can be in the range of 1 to 8.
Restriction
Reboot will not be available until VSF is enabled.

vsf member remove

This command removes the entire configuration for a specified member. After issuing the command, the specified
member-ID is available for reuse and may be provisioned or assigned to another device.
If the member physically exists, its configuration will be erased. It will then be powered down by default.
Syntax
vsf member <MEMBER-ID> remove
Description
Erase the VSF virtual chassis member configuration.
Parameters
<MEMBER-ID>
The VSF member-ID for the member command/ or parameter. Member ID value can be in the range of 1 to 8.
Restriction
Remove will not be available until VSF is enabled.

vsf member remove reboot

Syntax
vsf member <MEMBER-ID> remove reboot
Description
Removes the entire configuration for a specified member and reboots it. If the member physically exists, its
configuration will be erased. If the VSF link is still present, the member reboots and joins the stack through
automatic configuration.
Command context
config
Parameters
<MEMBER-ID>
The VSF member-ID for the member command/ or parameter. Member ID value can be in the range of 1 to 8.
658 Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08