Table of Contents
Advertisement
When this command is used the DEI Bit is left unchanged by the egress processing if a tag exists.
If a new tag is added, the DEI bit is set to 0.
This variant of the command is mutually exclusive to the use of dot1p-outer command. In other
words, user has a choice to use either this command or the dot1p-outer command but not both
together.
If the no form of the command is executed then the default remark values are used.
Default
no dot1p-outer
Parameters
in-profile dot1p-value — Specifies the Dot1p value to use for in-profile packets.
Values
out-profile dot1p-value — Specifies the Dot1p bits to use for the out-profile packets.
Values
7210 SAS D, E, K OS Quality of Service Guide
0-7
0-7
Page 463
Advertisement
Table of Contents
