Table of Contents
Advertisement
The meter must be created as multipoint. The multipoint designator cannot be defined after the meter is
created. If an attempt is made to modify the command to include the multipoint keyword, an error is
generated and the command will not execute.
The multipoint keyword can be entered in the command line on a pre-existing multipoint meter to edit
meter-id parameters.
Values
Default
meter
Syntax
meter meter-id
no meter
Context
config>qos>network>ingress>fc
Description
This command overrides the default unicast forwarding type meter mapping for fc fc-name. The
specified meter-id must exist within the policy as a non-multipoint meter before the mapping can
be made. Once the forwarding class mapping is executed, all unicast traffic on a port using this
policy is forwarded using the meter-id.
The no form of this command sets the unicast (point-to-point) meter-id back to the default meter
for the forwarding class (meter 1).
Default
meter 1
Parameters
meter-id — Specifies the meter-id. The specified parameter must be an existing, non-multipoint meter
defined in the config>qos>network>ingress context.
Values
multicast-meter
Syntax
multicast-meter meter-id
no multicast-meter
Context
config>qos>network>ingress>fc
Description
This command overrides the default multicast forwarding type meter mapping for fc fc-name. The
specified meter-id must exist within the policy as a multipoint meter before the mapping can be
made. Once the forwarding class mapping is executed, all multicast traffic on a port using this
policy is forwarded using the meter-id.
The no form of the command sets the multicast forwarding type meter-id back to the default meter
for the forwarding class.
Default
9
7210 SAS D, E, K OS Quality of Service Guide
multipoint or not present
Not present (the queue is created as non-multipoint)
1 — 12
Operational Commands
Page 163
Advertisement
Table of Contents
