Table of Contents
Advertisement
Basic Configurations
In the example above, assuming the policy is attached to a SAP in a VPLS service, the following
number of classification entries per FC:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 0 + 0 + 0 + 0 = 0
FCef = 0 + 0 + 0 + 0 = 0
FCh2 = 0 + 0 + 0 + 0 = 0
FCl1 = 0 + 0 + 0 + 0 = 0
FCaf = 1 + 0 + 1 + 0 = 3
Since this FC uses unicast meter, an entry is required to identify these traffic types explicitly.
Another entry is required to classify broadcast, multicast and unknown-unicast traffic type to the
same FC and use the default meter #11.
FCl2 = 0 + 0 + 0 + 0 = 0
FCbe = 1 + 1 + 1 + 0 = 3
Since this FC uses unicast, broadcast and multicast meter, three entries are required to identify
these traffic types explicitly. Unknown-unicast traffic type is classified using the same entry as
multicast traffic type and uses the same meter.
Using the equation, the total classification entries used by this policy is calculated as follows:
TC = (0 * 0)nc + (0 * 0)h1 + (0 * 0)ef + (0 * 0)h2 + (0 * 0)l1 + (15 * 3)af + (0 * 0)l2 + (1 *
3)be = 48
The total meters used in this policy = 4.
Hence, in this example,
rounded off to the next available numQosClassifier range .
If the same policy were to be used for a SAP in an Epipe service, then since all traffic is classified
to a unicast traffic type and since only unicast meters are used, the following are used:
FCnc = 0 + 0 + 0 + 0 = 0
FCh1 = 0 + 0 + 0 + 0 = 0
FCef = 0 + 0 + 0 + 0 = 0
Page 270
exit
entry 14 create
match
dscp cp15
exit
action fc "af"
exit
entry 15 create
match
dscp cp15
exit
action fc "af"
exit
exit
default-fc "be"
num-qos-classifiers 72
7210 SAS D, E, K OS Quality of Service Guide
are used (i.e. maximum of (48, (2 * 4)) = 48,
Advertisement
Table of Contents
