Table of Contents
Advertisement
When the policy is created, by default there will be only one queue that is created. User can create
up to 8 queues [1..8] and associate it to different FCs on the saps to which this sap-egress policy is
attached. SAP egress policy allows the user to define the queue parameters for the eight queues.
Default
1
Parameters
policy-id — The ID of the SAP Egress policy.
Values
remark
Syntax
remark policy-id
no remark
Context
config>qos>sap-egress
Description
Platforms Supported: 7210 SAS-K
This command specifies the remarking policy ID to use for marking packets on service egress
(also known as Access SAP egress).
The remarking policy ID must be associated with the appropriate SAP egress policy and
remarking must be enabled in the service egress policy to enable marking of packets sent out of
service (SAP) egress. Only remarking policy of type dot1p, dscp, or dot1p-dscp is allowed to be
used when the remark policy is associated with service egress. See the
remark policy and attachment points for 7210 SAS-K, on page 449
supported on the node and its use.
The no form of the command removes the explicit association of the remark policy and associates
the default remark policy. In other words, if remarking is enabled and no remark policy is
executed, then the default remark policy is used to mark packets sent out. If no remark policy is
executed and remarking is disabled, then packets are not remarked at all.
Parameters
policy-id — The parameter that uniquely identifies the remark policy.
Values
remarking
Syntax
[no] remarking
Context
config>qos>sap-egress
Description
Platforms Supported: 7210 SAS-K
Page 400
1 — 65535
1 — 65535
7210 SAS E OS Quality of Service Guide
Table 48, Summary of
for different remark policies
Advertisement
Table of Contents
