Table of Contents
Advertisement
Remark Policy Forwarding Class Commands
de-mark-outer
Syntax
[no] de-mark-outer [force de-value]
Context
config>qos> remark-policy> fc
Description
This command is used to explicitly define the marking of the DEI bit of the outermost tag for fc fc-
name according to the in and out of profile status of the packet.
If no de-value is present, the default values are used for the marking of the DE bit: for example, 0
for in-profile packets, 1 for out-of-profile ones – see IEEE 802.1ad-2005 standard.
If the de-value is specifically mentioned in the command line it means this value is to be used for
all the packets of this forwarding class regardless of their in/out of profile status.
Notes:
•
•
•
Parameters
de-value —
Values
dot1p-inner
Syntax
no dot1p-inner
dot1p-inner dot1p-value
Context
config> qos> remark> fc>
Description
Platforms Supported: 7210 SAS-K.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits for the inner VLAN tag
marking for fc-name. When the marking is set, all packets of fc-name that egresses out of QinQ
SAP only (that is, SAPs configured with two VLAN tags explicitly defined, For example: SAP 1/
1/5:10.100) use the explicitly defined dot1p-value.
7210 SAS D, E, K OS Quality of Service Guide
If remarking is enabled, the inner tag DEI is always set to zero irrespective of de-mark-
outer.
If remarking is enabled and de-mark-outer is not configured then, DEI bit of the outer tag
is set to zero.
If remarking is disabled then, the DEI bits are preserved for both inner and outer tag.
Specifies the DEI value to use for this forwarding class.
0 or 1
Page 459
Advertisement
Table of Contents
