Table of Contents
Advertisement
Network Ingress QoS Policy Commands
mbs
Syntax
mbs size-in-kbits
no mbs
Context
config>qos>network>ingress>meter
Description
Platforms Supported: 7210 SAS-E.
This command provides the explicit definition of the maximum amount of tokens allowed for a
specific meter. The value is given in kilobits and overrides the default value for the context.
In case of trTCM, the maximum burst size parameter specifies the maximum burst size that can be
transmitted by the source at the PIR while complying with the PIR. If the transmitted burst is
lower than the MBS value then the packets are marked as out-profile by the meter to indicate that
the traffic is not complying with CIR, but complying with PIR.
In case of srTCM, the maximum burst size parameter specifies the maximum burst size that can be
transmitted by the source while not complying with the CIR. The transmitted burst is lower than
the MBS value then the packets are marked as out-profile by the meter to indicate that the traffic is
not complying with CIR.
If the packet burst is higher than MBS then packets are marked as red are dropped by the meter.
The no form of this command returns the MBS size assigned to the meter to the default value.
Default
128Kbits
Parameters
size-in-kbits — This parameter is an integer expression of the maximum number of kilobits of burst allowed
for the meter. For example, for a value of 100 Kbits, enter the value 100.
Values
Page 166
32 — 16384, default
7210 SAS D, E, K OS Quality of Service Guide
Advertisement
Table of Contents
