Table of Contents
Advertisement
Generic Commands
queue
Syntax
queue queue-id [strict |weight weight]
no queue queue-id
Context
config>qos>port-sched-plcy
Description
This command configures a port scheduler queue. The queue and its weights can be configured
only for WRR/WDRR modes. The weight specified in case of WRR corresponds to the number of
packets that needs to be sent out in a cycle for that particular queue.
For WDRR, the weight specified is the ratio of traffic that will be sent out for that particular queue.
For example, in WDRR, if a weight value for queue 1 is 1 and a weight value for queue 2 is 5, then
traffic out of the port is in the ratio of 1:5 between the queues (1 and 2) provided no traffic is
flowing in the other queues. If the keyword strict is specified in any of the queues, then that
particular queue will be treated as strict. This set of strict priority queues is serviced first in the
order of their CoS numbering (the higher numbered CoS queue receives service before smaller
numbered queues).
The no form of the queue under a WRR/WDRR mode will set the queue weights to default (for
example, 1).
Parameters
queue-id — Specifies the queue ID.
Values
strict — Specifies strict access.
weight weight — Specifies the number of packets in case of WRR and ratio of traffic out in WDRR.
Values
Values
Page 462
1 — 8 (8 is the highest)
1 — 5 (For 7210 SAS-E)
1—15 (For 7210 SAS-D)
7210 SAS D, E, K OS Quality of Service Guide
Advertisement
Table of Contents
