Table of Contents
Advertisement
Show Commands
slope-policy
Syntax
slope-policy [slope-policy-name] [detail]
Context
show>qos
Description
This command displays slope policy information.
Parameters
slope-policy-name —
detail —
Output
Slope QoS Policy Output Fields (for 7210 SAS-E) — The following table describes slope QoS
policy output fields.
Table 53: Show QoS Slope Policy Output Fields
Policy
Description
Time Avg
Slope Parameters
Start Avg
Max Avg
Admin State
Max Prob.
7210 SAS D, E, K OS Quality of Service Guide
The name of the slope policy.
Displays detailed information about the slope policy.
Label
The ID that uniquely identifies the policy.
A string that identifies the policy's context in the configuration
file.
The weighting between the previous shared buffer average utili-
zation result and the new shared buffer utilization.
Specifies the low priority or high priority RED slope position for
the shared buffer average utilization value where the packet
discard probability starts to increase above zero.
Specifies the percentage of the shared buffer space for the buffer
pool at which point the drop probability becomes 1, expressed as
a decimal integer
Up —
Down —
Specifies the low priority or high priority RED slope position for
the maximum non-one packet discard probability value before
the packet discard probability rises directly to one.
Specifies the high priority RED slope position for the maximum
non-one packet discard probability value before the packet dis-
card probability rises directly to one.
Description
The administrative status of the RED slope is enabled.
The administrative status of the RED slope is disabled.
Show Commands
Page 513
Advertisement
Table of Contents
