Table of Contents
Advertisement
dot1p-outer
Syntax
no dot1p-outer
dot1p-outer dot1p-value
Context
config> qos> remark> fc>
Description
Platforms Supported: 7210 SAS-K.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. When
the marking is set, all packets of fc-name that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect.
If the no form of the command is executed then software will use the default value.
Default
no dot1p-outer
Parameters
dot1p-value —
Values
dscp-in-profile
Syntax
dscp-in-profile dscp-name
no dscp-in-profile
Context
config> qos> remark> fc
Description
Platforms Supported: 7210 SAS-K.
This command specifies the in-profile DSCP name for the forwarding class. When marking is set,
the corresponding DSCP value is used to mark all IP packets with in-profile status, on the egress
of this forwarding class queue.
When multiple DSCP names are associated with the forwarding class in the policy, the last name
entered will overwrite the previous value.
The no form of this command reverts to the factory default in-profile dscp-name setting for policy-
id 1.
Parameters
dscp-name — System- or user-defined, case-sensitive dscp-name.
Default
Values
7210 SAS D, E, K OS Quality of Service Guide
Specifies the dot1p values to use.
0-7
none
For 7210 SAS-K:
be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|af12|cp13|af13|cp15|cs2|cp17|af21|cp19|
af22|cp21|af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|cp33|af41|cp35|af42|cp3
7|af43|cp39|cs5|cp41|cp42|cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|cp54|cp
55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
Page 461
Advertisement
Table of Contents
