Table of Contents
Advertisement
dot1p-in-profile
Syntax
dot1p-in-profile dot1p-value
no dot1p-in-profile
Context
config>qos>access-egress>fc
Note: This command description is applicable only to 7210 SAS-E.
This command explicitly defines the egress IEEE 802.1P (Dot1p) bits marking for fc-name. All
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined Dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the command has no effect. The dot1p-in-profile
dot1p-value and dot1p-out-profile dot1p-value structure will add the capability to mark Dot1p on
an egress access port the in and out of profile packets. If the user has not explicitly configured the
FC-Dot1p map the marking of packets is still done according to
Policy ID 1 Definition, on page
commands.
The no form of the command sets the IEEE 802.1P or IEEE 802.1Q priority bits to default FC-
Dot1P marking map as listed in
Default
0
Dot1p values are marked according to
Parameters
dot1p-value — This value specifies the unique IEEE 802.1P value that will match the dot1p rule. If the
command is executed multiple times with the same dot1p-value, the previous forwarding class and
enqueuing priority is completely overridden by the new parameters or defined to be inherited when a
forwarding class or enqueuing priority parameter is missing.
A maximum of eight dot1p rules are allowed on a single policy.
Values
dot1p-out-profile
Syntax
dot1p-out-profile dot1p-value
no dot1p-out-profile
Context
config>qos>access-egress>fc
Description
Note: This command description is applicable only to 7210 SAS-E.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. All
packets belonging to a particular FC that have either an IEEE 802.1Q or IEEE 802.1P
encapsulation use the explicitly defined dot1p-value. If the egress packets for fc-name are not
IEEE 802.1Q or IEEE 802.1P encapsulated, the dot1p command has no effect. The dot1p-in-
profile dot1p-value and dot1p-out-profile dot1p-value commands will provide the capability to
Page 358
0 — 7
7210 SAS D, E, K OS Quality of Service Guide
66. User can explicitly define the new Dot1P values using these
Table 23, Default SAP Egress Policy ID 1 Definition, on page
Access Egress Default Policy Details on page
Table 23, Default Service Egress
356.
57.
Advertisement
Table of Contents
