Table of Contents
Advertisement
IP QoS Policy Match Commands
precedence bits value that will match the IP precedence rule.
Values
mask — The mask to use for the match.
src-ip
Syntax
src-ip {ip-address/mask | ip-address netmask}
no src-ip
Context
config>qos>sap-ingress>ip-criteria>entry>match
config>qos>sap-egress>ip-criteria>entry>match
config>qos>sap-ingress>ipv6-criteria>entry>match
Description
This command configures a source IP or IPv6 address range to be used as an SAP QoS policy match
criterion.
To match on the source IP or IPv6 address, specify the address and its associated mask, e.g. 10.1.0.0/16. The
conventional notation of 10.1.0.0 255.255.0.0 can also be used.
The no form of the command removes the source IP or IPv6 address match criterion.
Default
No source IP match criterion.
Parameters
ip-address | ipv6-address — The IP or IPv6 address of the source IP interface. This address must be unique
within the subnet and specified in dotted decimal notation.
Values
Values
Values
mask — The subnet mask length, expressed as an integer or in dotted decimal notation.
Values
netmask — Specify the subnet mask in dotted decimal notation.
Values
Page 322
0 — 7
ip-address:
mask:
netmask
ipv4-prefix: a.b.c.d
ipv4-prefix-length: 0 -- 32
ipv6-prefix: x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
ipv6-prefix-length: 0 -- 128
netmask
0.0.0.0 - 255.255.255.255
0 — 32
a.b.c.d (dotted quad equivalent of mask length)
7210 SAS D, E, K OS Quality of Service Guide
a.b.c.d
1 — 32
a.b.c.d (dotted quad equivalent of mask length)
x: [0..FFFF]H
d: [0..255]D
Specifies the subnet mask in dotted decimal notation.
Advertisement
Table of Contents
