Table of Contents
Advertisement
NOTE: The following rules are applied by software to determine the Dot1p values to when both
dot1p command and dot1p-in-profile and dot1p-out-profile command is specified:
1. If de-mark is not configured, then dot1p [in|out]-profile values are considered. Even if `dot1p
<val>' command is configured it is ignored and if `dot1p [in|out]-profile' value is not config-
ured then default values are considered for that FC.
2. If de-mark is configured and if `dot1p <value>' command is configured then it is considered.
Else if `dot1p [in|out]-profile' value is configured it is considered. In this case `dot1p <val>',
has the precedence over `dot1p [in|out]-profile'.
3. If marking is enabled and both dot1p <val> and dot1-[in|out]-profile commands are not speci-
fied, then the default values for default.
Default
0
Parameters
dot1p-priority — Specifies the 802.1p value to set for in-profile frames in this forwarding class.
Values
dscp-out-profile
Syntax
dscp-out-profile dscp-name
no dscp-out-profile
Context
config>qos>access-egress>fc
Description
Platforms Supported: 7210 SAS-D.
This command specifies the out-of-profile DSCP name for the forwarding class. When marking is
set, the corresponding DSCP value is used to mark all IP packets with out-of-profile status, on the
egress of this forwarding class queue.
When multiple DSCP names are associated with the forwarding class at network egress, the last
name entered will overwrite the previous value.
The no form of this command reverts to the factory default out-of-profile dscp-name.
Parameters
dscp-name —
Values
7210 SAS D, E, K OS Quality of Service Guide
0 — 7
Specifies the DSCP name.
be|cp1|cp2|cp3|cp4|cp5|cp6|cp7|cs1|cp9|af11|cp11|
af12|cp13|af13|cp15|cs2|cp17|af21|cp19|af22|cp21|
af23|cp23|cs3|cp25|af31|cp27|af32|cp29|af33|cp31|cs4|
cp33|af41|cp35|af42|cp37|af43|cp39|cs5|cp41|cp42|
cp43|cp44|cp45|ef|cp47|nc1|cp49|cp50|cp51|cp52|cp53|
cp54|cp55|nc2|cp57|cp58|cp59|cp60|cp61|cp62|cp63
Page 361
Advertisement
Table of Contents
