Table of Contents
Advertisement
Generic Commands
Operational Commands
copy
Syntax
copy network src-pol dst-pol [overwrite]
Context
config>qos
Description
This command copies existing QoS policy entries for a QoS policy-id to another QoS policy-id.
The copy command is used to create new policies using existing policies and also allows bulk
modifications to an existing policy with the use of the overwrite keyword.
network src-pol dst-pol — Indicates that the source and destination policies are network policy IDs.
Parameters
Specify the source policy that the copy command will copy and specify the destination policy to which
the command will duplicate the policy to a new or different policy ID.
Values
overwrite — Specifies to replace the existing destination policy. Everything in the existing destination
policy will be overwritten with the contents of the source policy. If overwrite is not specified, an error
will occur if the destination policy ID exists.
SR>config>qos# copy network 1 427
MINOR: CLI Destination "427" exists use {overwrite}.
SR>config>qos# copy network 1 427 overwrite
remarking
Syntax
remarking
Context
config>qos>network>egress
Description
Platforms Supported: 7210 SAS-E
Remarking is always enabled on the access uplink ports.
The 7210 SAS-E will be used to potentially connect to a particular diffserv domain using the L2
uplink ports it is very important that each and every packet ingressing on the 7210 SAS-E is
mapped and marked and thereby assigned to a particular diffserv class while going through the
network. The downstream node, a 7x50 router, will be assigning the FC based on the Dot1P
assigned in 7210 SAS-E.
The no form of this command is not supported.
Default
remarking (that is, remarking is enabled, it cannot be disabled).
Page 152
1 — 65535
7210 SAS D, E, K OS Quality of Service Guide
Advertisement
Table of Contents
