Table of Contents
Advertisement
remarking
Syntax
[no] remarking {use-dot1p|use-dscp|all}
Context
config>qos>network>egress
Description
Platforms Supported: 7210 SAS-D
This command enables the system to remark egress packets sent out of access ports and access-
uplink ports. For 7210 SAS-D, remarking can be enabled or disabled. On access port and access-
uplink port egress, the behavior is as follows:
•
•
•
NOTE: If remarking is enabled without specifying one of the options, by default 'use-dot1p' is
used for access-egress and "all" is used for network-egress.
The no form of the command disables remarking, which is the default behavior.
Default
no remarking (that is, remarking is disabled).
remark
Syntax
remark policy-id
no remark
Context
config>qos>network>egress
Description
Platforms Supported: 7210 SAS-K
This command specifies the remarking policy ID to use for marking packets on access-uplink port
egress.
The remarking policy ID must be associated with the appropriate network QoS policy associated
with the access-uplink port and remarking must be enabled in the network QoS policy to enable
marking of packets sent out of access-uplink port egress. Only remarking policy of type dot1p,
dscp, or dot1p-dscp is allowed to be used when the remark policy is associated with access-uplink
port egress. See the
page 54
7210 SAS D, E, K OS Quality of Service Guide
If 'use-dot1p' is configured, then the dot1p bits are marked in the packet header for all
IEEE 802.1q and IEEE 802.1p encapsulated traffic sent out of the access port.
If 'use-dscp' is configured, then the IP DSCP bits are marked in the packet header for IPv4
traffic sent out of the access port.
If 'all' is configured, then the Dot1p bits are marked in the packet header for all IEEE
802.1q and IEEE 802.1p encapsulated traffic and in addition the IP DSCP bits are marked
in the packet header for all IPv4 traffic sent out the access port.
Table 7, Summary of remark policy and attachment points for 7210 SAS-K, on
the different remark policies supported on the node and its use.
Operational Commands
Page 153
Advertisement
Table of Contents
