Table of Contents
Advertisement
remarking
Syntax
remarking
Context
config>qos>access-egress
Description
Platforms Supported: 7210 SAS-E
This command enables the system to remark egress packets on access ports (that is, customer
facing ports). Remarking cannot be disabled on the access ports on 7210 SAS-E.
The no form of the command is not supported.
Default
remarking (that is, remarking is enabled, it cannot be disabled).
remarking
Syntax
[no] remarking {use-dot1p|use-dscp|all}
Context
config>qos>access-egress
Description
Platforms Supported: 7210 SAS-D
This command enables the system to remark egress packets sent out of access ports and access-
uplink ports. For 7210 SAS-D, remarking can be enabled or disabled. On access port and access-
uplink port egress, the behavior is as follows:
•
•
•
NOTE: If remarking is enabled without specifying one of the options, by default 'use-dot1p' is
used for access-egress and "all" is used for network-egress.
The no form of the command disables remarking, which is the default behavior.
Default
no remarking (that is, remarking is disabled).
7210 SAS D, E, K OS Quality of Service Guide
If 'use-dot1p' is configured, then the dot1p bits are marked in the packet header for all
IEEE 802.1q and IEEE 802.1p encapsulated traffic sent out of the access port.
If 'use-dscp' is configured, then the IP DSCP bits are marked in the packet header for IPv4
traffic sent out of the access port.
If 'all' is configured, then the Dot1p bits are marked in the packet header for all IEEE
802.1q and IEEE 802.1p encapsulated traffic and in addition the IP DSCP bits are marked
in the packet header for all IPv4 traffic sent out the access port.
Page 363
Advertisement
Table of Contents
