Table of Contents
Advertisement
default-fc
Syntax
default-fc fc [profile {in|out|use-dei}]
Context
config>qos>sap-ingress
Description
This command configures the default forwarding class for the policy. In the event that an ingress packet does
not match a higher priority (more explicit) classification command, the default forwarding class will be
associated with the packet. Unless overridden by an explicit forwarding class classification rule, all packets
received on an ingress SAP using this ingress QoS policy will be classified to the default forwarding class.
The default forwarding class is best effort (be). The default-fc settings are displayed in the show
configuration and save output regardless of inclusion of the detail keyword.
Context
be
Parameters
fc — Specify the forwarding class name for the queue/meter. The value given for fc must be one of the
predefined forwarding classes in the system.
profile {in | out} — The profile assignment action is optional. When specified, packets matching the
classification entry will be explicitly classifier to either in-profile or out-of-profile. The remove the
profile action for an classification entry, the action command must be re-executed without the profile
action defined. The profile assigned by the user is used subsequently to determine the slope to use at the
ingress and egress queuing points and is used for egress marking (if enabled).
in — The in parameter is mutually excusive to the out parameter following the profile classification action
keyword. Either in or out must be specified when the profile keyword is present. When in is specified,
any packets matching the classification rule will be treated as in-profile.
out — The out parameter is mutually excusive to the in parameter following the profile classification action
keyword. Either in or out must be specified when the profile keyword is present. When out is specified,
any packets matching the classification rule will be treated as out-of-profile.
use-dei — Specifies whether DEI must be used to determine the initial profile of the packet. Supported
only on 7210 SAS-K.
use-dei
Syntax
[no] use-dei
Context
config>qos>sap-ingress>fc
Description
Platforms Supported: 7210 SAS-K.
This command is used to enable DEI based classification. When enabled, the packet classified to
this FC the DEI bit is used to determine the ingress profile for the packet. Packets received with
DEI bit set to zero are treated as in-profile and packets with DEI bit set to one are treated as out-of-
profile packets.
7210 SAS D, E, K OS Quality of Service Guide
Operational Commands
Page 305
Advertisement
Table of Contents
