Table of Contents
Advertisement
This command has no effect for egress packets sent out of all other non-QinQ SAPs for example:
Dot1q SAP, NULL SAP, etc. Additionally, if the egress packets for fc-name are not IEEE 802.1Q
or IEEE 802.1P encapsulated, this command has no effect. In other words, this command takes
effect, only when the node adds 2 tags to the packet on the egress.
If the no form of the command is executed, the default remarking values are used.
Default
no dot1p-inner
Parameters
dot1p-value —
Values
dot1p-inner
Syntax
[no] dot1p-inner [in-profile dot1p-value] [out-profile dot1p-value]
Context
config> qos> remark> fc
Description
The command will add the capability to mark on an egress the in and out profile status through a
certain dot1p combination. It may be used when the internal in and out of profile status needs to be
communicated to an adjacent network/customer device that does not support the DEI bit.
This command explicitly defines the egress IEEE 802.1P (dot1p) bits marking for fc-name. When
the marking is set, all packets with in-profile status (or green color) of fc-name that egress out of
QinQ SAP only (i.e. SAPs configured with two VLAN tags explicitly defined, e.g. SAP 1/1/
5:10.100) use the explicitly defined in-profile and out-profile dot1p-value.
This command has no effect for egress packets sent out of all other non-QinQ SAPs e.g. Dot1q
SAP, NULL SAP, etc. Additionally, if the egress packets for fc-name are not IEEE 802.1Q or IEEE
802.1P encapsulated, this command has no effect. In other words, this command takes effect, only
when the node adds 2 tags to the packet on the egress.
This variant of the command is mutually exclusive to the use of dot1p-inner command. In other
words, user has a choice to use either this command or the dot1p-inner command but not both
together.
If the no form of the command is executed, default remarking values are used for marking the
inner VLAN.
Default
no dot1p-inner
Parameters
in-profile dot1p-value — Specifies the Dot1p value to use for in-profile packets.
Values
out-profile dot1p-value — Specifies the Dot1p bits to use for the out-profile packets.
Values
Page 460
Specifies the 802.1p value to set for the frames in this forwarding class.
0 — 7
0-7
0-7
7210 SAS D, E, K OS Quality of Service Guide
Advertisement
Table of Contents
