Table of Contents
Advertisement
Remark Policy QoS Commands
remark
Syntax
no remark policy-id
remark policy-id [create] [remark-type remarking type]
Context
config>qos
Description
Platforms Supported: 7210 SAS-K.
This command creates a new remark policy of the specified type.
The following types of remark policies are available:
•
•
•
The 'remark-type' of the policy also determines the values user is allowed to configure in the
policy and the QoS policy with which this policy can be associated with. See the
Summary of remark policy and attachment points for 7210 SAS-K, on page 449
remark policies supported on the node and its use.
NOTE: On 7210 SAS-K a limited number of unique remark policies are available to be shared
among all the different types of remark policies. In other words, dot1p, dscp and dot1p-dscp
remark policy types share the available resources and scaling one type of remark policy reduces
the amount policies allowed for other type of remark policy.
Default
no default
Parameters
policy-id —
Values
remarking-type —
Values
7210 SAS D, E, K OS Quality of Service Guide
dot1p
dscp
dot1p-dscp
The policy ID of the remark policy.
[1..65535]
Specifies the type of marking values in the remark policy.
dot1p — Specify FC to 802.1 Dot1p value to use for marking. It is the default used if user
does not explicitly specify the remarking-type value.
dscp— Specify FC to IP DSCP value to use for marking.
dot1p-dscp - Specify FC to both Dot1p and IP DSCP values to use for marking.
Table 48,
the different
Page 457
Advertisement
Table of Contents
