Settings For Judgment Output - Omron ZW Series User Manual

Chapter 4
Settings for I/O

Settings for Judgment Output

The following describes the settings for outputting the judgment results from the judgment
output of the 20-pole terminal block.
■ Assignment of judgment output
Sets the task for which to output the judgment results.
Setting [Display]
TASK1 [TASK1]
(Default value)
TASK2 [TASK2]
TASK3 [TASK3]
TASK4 [TASK4]
With binary output, judgment results for all the tasks can be output.
As an example, here is an explanation of the procedure for outputting the judgment
results for TASK1.
Operating procedure
Steps
1
2
3
4
5
ZW
4-18
User's Manual
The judgment results for the selected task are output from the following
output terminals of the 20-pole terminal block.
• HIGH1
• PASS1
• LOW1
• BUSY1
Settings for Binary Output p.4-22
Key operation Display
RUN RUN
H L
FUN FUN
L
TEACH TEACH
ZERORST/ ZERORST/ ESC ESC
ZERO/ SET ZERO/ SET
ZERORST/ ESC ZERORST/ ESC
ZERO/ ZERO/ SET SET
Description
RUN RUN
Press key for two seconds to enter the FUN
UNLIT
FUN FUN
L
TEACH TEACH
mode.
RUN RUN
Press or keys to select either of "I/O" and
press key.
ZERO/ SET ZERO/ SET
Press or keys to select either of "JUDGE"
and press key.
ZERO/ SET SET
ZERO/
Press or keys to select either of "OUTPUT"
and press key.
ZERO/ ZERO/ SET SET
Select "TASK1" as the task to output judgment for.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "TASK1" and press
Description
key.
ZERO/ SET SET
ZERO/