Omron ZW Series User Manual page 105

■ Thickness scaling
The thickness is measured at one position and offset values are set for that measured
value.
Operating procedure
Steps Key operation
1 - 5 For moving to SCALE, see steps 1 to 5 in p.3-22
6
ZERORST/ ZERORST/ ESC
ZERO/ SET ZERO/
7
ZERORST/ ESC ZERORST/
ZERO/ SET ZERO/
8
ZERORST/ ESC ZERORST/
ZERO/ ZERO/ SET
9
RUN RUN
FUN FUN
L
TEACH TEACH
Display
ESC
SET
ESC
SET
ESC
SET
LIT
H L RUN RUN
Setting the Output Conditions
Description
Select "Thick" as the scaling type.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "THICK" and press
ZERO/ SET
ZERO/
The current measured value is displayed on the main
display and the current setting value is displayed on
the sub-display.
Press key to enter the editing mode, and the
ZERO/ SET ZERO/ SET
sub-display blinks.
To edit numerical values use
Enter the setting value and then press
"OK/CAN" is displayed on the sub-display.
Press key to execute the scaling or
ZERO/ SET ZERO/ SET
to cancel.
RUN RUN
Press key for two seconds to enter the RUN
FUN FUN
L
TEACH TEACH
mode.
Chapter 3
key.
SET
/ / / keys.
key.
ZERO/ ZERO/ SET SET
ZERORST/ ESC ZERORST/ ESC
key
ZW
User's Manual
3-27