Table of Contents
Advertisement
Chapter 4
Timing Charts
■ Auto peak/Auto bottom/Auto peak to peak hold
Reset output
(RESET)
Busy output
Judgment output
(HIGH/PASS/LOW)
Binary output
GATE output
Analog output
T3
Response time of analog output
T4
GATE signal rise time
T5
Output time of GATE signal
T6
Trigger input/reset input minimum
time'
T7
Response time of input
● Explanation of operations
(1)
The peak value is updated and the judgment results and binary data are output.
(2)
After the judgment result and binary data output, the analog output is updated.
(3)
After the judgment result and binary data output, the GATE signal is turned ON.
(4)
The GATE output time after the GATE signal is turned ON, the GATE signal is
turned OFF.
(5)
The reset signal is turned ON. During the reset input minimum time, if the reset
signal is turned ON, the measured value is reset.
(6)
The judgment results and binary data are reset. The BUSY signal is turned OFF.
(7)
After the judgment results and binary data are reset, the analog output is reset.
(8)
After the judgment result and binary data output, the GATE signal is turned ON.
(9)
The GATE output time after the GATE signal is turned ON, the GATE signal is
turned OFF.
(10) The reset signal is turned OFF.
(11) The BUSY signal is turned ON.
ZW
4-36
User's Manual
(3)
(1) (2)
(4)
T4
T5
T3
ON
OFF
ON
OFF
ON
OFF
Item
(5)
(6)(7) (8)
T6
T7
Minimum
-
-
Setting value
(0.1 to 100.0 ms)
3 ms+T0
2 ms+T0
(9) (10)
(11)
T4
T5
T3
T7
Maximum
0.1 ms
0.2 ms
Setting value
(0.1 to 100.0 ms)
-
3 ms+T0u2
Advertisement
Table of Contents
