Omron ZW Series User Manual page 94

Chapter 3
Setting the Output Conditions
■ Setting the average value filter
The average of the measured values obtained based on the preset number of samples
can be output. Select this setting when you want to ignore sudden changes in
measured values.
1/2/4/8/16/32/64/128/256/512/
1024/2048/4096
(Default value: 256)
As an example, here is an explanation of the procedure for selecting the "128" average
count setting.
Operating procedure
Steps
1 - 4 For moving to FILTER, see steps 1 to 4 in p.3-15
5
6
7
ZW
3-16
User's Manual
Setting
Sets the average count.
Key operation Display
ZERORST/ ESC ESC
ZERORST/
ZERO/ ZERO/ SET SET
ZERORST/ ZERORST/ ESC ESC
ZERO/ SET ZERO/ SET
RUN RUN
H L
FUN FUN
L
TEACH TEACH
Description
Select "Average filter" as the filter type.
Press or keys to select either of "AVE" and
press key.
ZERO/ SET ZERO/ SET
Select "128" as the average count.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "128" and press
RUN RUN
Press key for two seconds to enter the RUN
LIT
FUN FUN
L
TEACH TEACH
mode.
RUN RUN
Description
key.
ZERO/ SET SET
ZERO/