Omron ZW Series User Manual page 141

Steps Key operation
5
ZERORST/ ZERORST/ ESC
ZERO/ ZERO/ SET
6
RUN RUN
FUN FUN
L
TEACH TEACH
■ Assignment of analog output
Sets the task for which to output the results as analog.
Setting [Display]
TASK1 [TASK1]
(Default value)
TASK2 [TASK2]
TASK3 [TASK3]
TASK4 [TASK4]
OFF [OFF]
As an example, here is an explanation of the procedure for outputting the results of
TASK1 as analog.
Operating procedure
Steps Key operation
1 - 3 For moving to ANALOG, see steps 1 to 3 in p.4-12
4
ZERORST/ ESC ZERORST/
ZERO/ SET ZERO/
5
ZERORST/ ZERORST/ ESC
ZERO/ SET ZERO/
6
RUN RUN
FUN FUN
L
TEACH TEACH
Display
ESC
SET
LIT
H L RUN RUN
The measured value for the selected task is output from the Controller as
analog.
No analog output.
Display
ESC
SET
ESC
SET
LIT
H L RUN RUN
Description
Select "Voltage output" as the output destination.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "VOLT" and press
ZERO/ ZERO/ SET
RUN RUN
Press key for two seconds to enter the RUN
FUN FUN
L
TEACH TEACH
mode.
Description
Description
Press or keys to select either of "OUTPUT"
and press key.
ZERO/ ZERO/ SET SET
Select "TASK1" as the task to output for.
The current setting value is displayed on the sub-
display.
Press / keys to enter the editing mode, and the
sub-display blinks.
Select "TASK1" and press
ZERO/ SET ZERO/
RUN RUN
Press key for two seconds to enter the RUN
FUN FUN
L
TEACH TEACH
mode.
Chapter 4
Settings for I/O
key.
SET
key.
SET
ZW
User's Manual
4-13