Omron ZW Series User Manual page 117

■Offset
Set an offset to set the reference value for zero reset to a value other than 0.
Setting [Display]
Offset [OFFSET]
As an example, here is an explanation of the procedure for selecting the "10 mm"
reference value setting.
Operating procedure
Steps Key operation
1 - 5 For moving to ZERO, see steps 1 to 5 in p.3-38
6
ZERORST/ ZERORST/ ESC
ZERO/ SET ZERO/
7
ZERORST/ ESC ZERORST/
ZERO/ SET ZERO/
8
ZERORST/ ESC ZERORST/
ZERO/ SET ZERO/
9
RUN RUN
FUN FUN
L
TEACH TEACH
Sets the reference value.
Range: -999.999999 to 999.999999 mm (Default value: 0)
Display
ESC
SET
ESC
SET
ESC
SET
LIT
H L RUN RUN
Setting the Output Conditions
Description
Description
Press or keys to select either of "OFFSET"
and press key.
ZERO/ SET ZERO/ SET
Set "10" as the reference value.
The current setting value is displayed on the sub-
display.
Press key to enter the editing mode, and the
ZERO/ SET ZERO/ SET
sub-display blinks.
To edit numerical values use
Enter "10" and press
ZERO/ SET ZERO/ SET
The decimal point is displayed.
Press / key to move the decimal point.
Determine the decimal point and then press the
key.
RUN RUN
Press key for two seconds to enter the RUN
FUN FUN
L
TEACH TEACH
mode.
Chapter 3
/ / / keys.
key.
ZERO/ SET SET
ZERO/
ZW
User's Manual
3-39